Introduction
8 CP-R25 Hardware and AS-B01 Software Manual
1. Introduction
Rosslare's CP-R25 is a desktop Mifare
®
and fingerprint card programmer for
Mifare
®
1K and 4K RFID proximity cards and tags.
The CP-R25 makes managing fingerprint and Mifare
®
cards easier and can help
facilitate the effective deployment and control of any facility code application,
including access control, intrusion, and time and attendance applications.
1.1 The CP-R25 System
The CP-R25 is built for high-security, portability and ease of use, enabling high
quality Mifare
®
and fingerprint enrollment at a low cost.
The CP-R25 programmer is controlled by computer using Rosslare's powerful
AS-B01 Programmer software package.
1.2 Desktop Convenience
The CP-R25 is small and lightweight, with a slim and attractive design. It is
built for convenience and portability, with a USB 2.0 computer interface, which
makes it quick to install and allows it to run without any additional power
source.
Figure 1: The CP-R25
Designed to sit safely on any desktop, the CP-R25 is sturdily built, with large
card and fingerprint trays and surface-gripping rubber feet.
1.3 Intuitive Software System
The AS-B01 is a software application intended for programming Mifare
®
cards,
tags and fingerprints using Rosslare's CP-R25 Desktop Programmer.
The system includes a security authentication system and a real-time
operations log.
Using this tool requires basic understanding of Mifare
®
cards memory
architecture and access condition mechanisms.
To Next Page
Loading...
