Rotax 125 MAX evo - Page 8

ROTAX 125 MAX evo, Junior MAX evo, Mini MAX evo, Micro MAX evo
Table of contents of Installation Instructions
1. General ..................................................................................................................................... 51
2. Finalizing of engine assembly ............................................................................................... 51
2.1. Installation and connection of the electric and electronic components ............................ 51
2.1.1. Installation of the ignition coil .................................................................................... 51
2.1.2. Fitting of the spark plug ............................................................................................ 52
2.1.3. Installation and connection of the RAVE control unit (125 MAX only) ...................... 53
2.1.4. Installation of the ECU .............................................................................................. 53
3. Verification or replenishing of oil level in gear compartment ............................................ 54
4. Engine attachment on chassis .............................................................................................. 55
4.1. Attachment via engine pedestal ....................................................................................... 55
4.2. Direct attachment of the engine on chassis ..................................................................... 55
5. Fitting of the drive chain ........................................................................................................ 56
6. Installation of the battery and the wiring harness ............................................................... 57
6.1. Installation of the wiring harness ..................................................................................... 57
7. Installation and connection of the fuel system .................................................................... 60
7.1. Installation and connection of the fuel pump ................................................................... 60
7.2. Installation and connection of the carburetor ................................................................... 62
8. Installation of the Bowden cable for carburetor control ..................................................... 63
9. Installation of the radiator ...................................................................................................... 64
10. Installation of the intake silencer with integrated airfilter ................................................... 66
11. Installation of the exhaust system ........................................................................................ 67
12. Finishing work ......................................................................................................................... 69
12.1. Venting of the gear compartment .................................................................................... 69
Seite/page 7/98 Ausgabe/Edition 11/2014