Section 5 Operating Instructions H85A Manual
www.rottlermfg.com
5-22
Consult the tooling charts in the previous section to determine which hone head and stone holders will be
needed for the job you are setting up for.
Prior to hone head installation conrm that the con rod is at least 1/4”(6mm) up inside the hone body. This
will assure that the homing procedure will function correctly.
Once the hone head is attached release the E-STOP switch and touch the Home button to calibrate the
hone head set up to the machine program.
Once homing is complete, check that cone rod is all the way up inside the hone head before proceeding.
THIS IS CRITICAL. If for some reason the cone rod doesn’t reach it’s upper most travel point when
homing is completed, then the bore size range will not be properly calibrated. This could result in the cone
rod coming out of the hone body during operation and could potentially cause damage.
IMPORTANT: Whenever a hone head set up is changed the machine must be
Homed.
Now that the machine is set up for honing we will construct a program to hone the block.
To Next Page
Loading...
