Enabling Other Management Access Options
Ruckus Wireless Outdoor AP 100.1.0 User Guide, 800-70863-001 Rev A 128
Auto-provisioning This setting is disabled by default, and should only be enabled if
using a FlexMaster server for AP management.
Start Recovery SSID
after ___ seconds of
connectivity loss
When connectivity is lost for this time, the recovery process is
invoked. Default is 300 seconds. Enter 0 to disable this function.
(Only available on selected APs.)
Continue service
WLANs when in
recovery mode
When the recovery process is invoked, the WLAN service is
continued (Enabled) or halted (Disabled). (Only available on
selected APs.)
Controller Discovery
Agent (LWAPP)
• Enabled (default) -- Lightweight Access Point Protocol
controller discovery on. (Refer to
Release Notes for details.)
• Disabled -- LWAPP controller discovery off.
Cloud Discovery
Agent (FQDN)
• Enabled (default) -- Fully Qualified Domain Name cloud
discovery on; requires enabled LWAPP controller discovery
Enabled. (Refer to
Release Notes for details.)
• Disabled -- FQDN cloud discovery off.
Set Controller
Address
• Enabled -- The AP uses an IP address to search for the primary
and/or secondary SCG, vSCG, SZ or ZD controller. When Set
Controller Address is Enabled, enter the required primary
controller IP address and the optional secondary controller IP
address.
• Disabled (default) -- The AP does not use IP address(es) to
search for SCG, vSCG, SZ or ZD controllers.
Auto-provisioning
(some APs)
This setting is disabled by default, and should only be enabled if
using FlexMaster server for AP management.
Table 37. Management Access Options (Continued)
Option Description
To Next Page
Loading...
