Enabling Other Management Access Options
Ruckus Wireless Outdoor AP 100.1.0 User Guide, 800-70863-001 Rev A 129
3 If you want to use TR-069 or SNMP to manage the AP, then configure the settings
listed in Tab l e 38.
4 Click Update Settings to save your changes. A confirmation message appears
at the top of the page.
You have completed configuring the management access options.
NOTE Remember to open any relevant firewall ports between the AP and the AP
image upgrade/management server. For example, if HTTPS is used for image
upgrades, open TCP port 443 on the firewall to allow connections through port 443.
If FlexMaster server is used, open TCP ports 80 and 443 for HTTP/HTTPS
communications, and TCP port 8082 for AP wake-up commands. (Refer to Release
Notes for details.)
Table 38. TR-069 and SNMP Management Options
Option Description
Auto (Default) Enables the Ruckus Wireless device to be
managed by either SNMP servers, Ruckus Wireless
controllers, or Ruckus Wireless FlexMaster. (Refer to
Release Notes for details.)
SNMP only Only allow SNMP management.
FlexMaster only Only allow FlexMaster management.
None Do not allow SCG, vSCG, SZ or ZD control or FlexMaster
management.
DHCP Discovery URL of server providing DHCP.
FlexMaster Server URL URL of the FlexMaster server.
Digest-Authentication
Username/Digest-
Authentication Password
This information is automatically generated by the AP and
used for authentication with FlexMaster. Change this value
only
if you want the AP to connect to another access
control server (ACS).
Periodic FlexMaster Inform
Interval
Interval at which the device should attempt to contact
FlexMaster. (Default = 15 minutes.)
To Next Page
Loading...
