Getting to Know the Access Point Features
ZoneFlex 7781CM Access Point with Cable Modem
Ruckus Wireless Outdoor AP 100.1.0 User Guide, 800-70863-001 Rev A 37
NOTE The 7781CM LEDs turn off after a while. This is normal operation.
Reading LEDs in Access Point Mode
In AP mode, LED 1 (green LED) is lit.
NOTE The LEDs do not indicate whether the AP is in standalone mode or if
ZoneDirector is managing the AP. To check if ZoneDirector is managing the AP, log
into the ZoneDirector Web interface, go to the APs page, and then search for the
AP’s MAC address. If you are unable to find th e AP, then it is very likely in standalone
mode. If you have multiple ZoneDirector devices on the network, make sure you
check each one of them.
For Cable Operators, APs will typically be in ZoneDirector mode after initial boot. If
the AP is unable to reach the ZoneDirector on initial boot, it remains in standalone
mode.
Refer to Tabl e 1 2 for a summary of AP mode LED behavior.
Table 12. 7781CM LED behavior in AP Standalone and ZoneDirector modes
LED State AP Standalone Mode AP ZoneDirector Mode
1
Solid
Green
On = AP Mode. On = AP Mode.
2
OFF Off = Not AP Mode. Off = Not AP Mode.
3
Solid
Blue
At least one 5GHz wireless client
is associated with the access
point and signal strength is weak.
If AP is RAP, at least one MAP is
associated. If AP is MAP it is
associated with a RAP. Signal
strength is weak.
4
Flashing
Green
5GHz WLAN is up but no clients. 5GHz WLAN is up but no clients.
Solid
Green
At least one 5GHz wireless client
is associated with the access
point and signal strength is strong.
If AP is RAP, at least one MAP is
associated. If AP is MAP it is
associated with a RAP. Signal
strength is strong.
5
Solid
Yellow
At least one 2.4GHz wireless
client is associated with the
access point and signal strength
is weak.
At least one 2.4GHz wireless
client is associated with the
access point and signal strength
is weak.
To Next Page
Loading...
