Configuring Wireless Settings
Configuring Common Wireless Settings
Ruckus Wireless Outdoor AP 100.1.0 User Guide, 800-70863-001 Rev A 88
3 Click Update Settings to save your changes.
Ekahau RFID (Some APs only.) If you are using an Ekahau Real Time Location
System (RTLS) in your organization, then you can use your
Ruckus Wireless AP to relay location or presence data to the
Ekahau Real Time Location System RTLS Controller (ERC).
• Select
Enabled to support Ekahau RFID tag detection.
• If you have enabled Ekahau, then complete the following:
ERC IP Address: Enter an IP address for the Ekahau Real Time
Location System RTLS Controller.
ERC port: 65538 is the default, but it can be set to any available
TCP port used by the Ekahau Real Time Location System
RTLS Controller.
For other Ekahau-related configuration, refer to the Ekahau
documentation that was shipped with your Ekahau Real Time
Location System RTLS Controller.
Note: If ZoneDirector exists on the network, you can enable
AeroScout RFID tag detection on all its managed APs at once.
Refer to the ZoneDirector online help.
Table 24. Common Wireless Settings (Continued)
To Next Page
Loading...
