SAGEMCOM F@ST 4310 User Manual

8- Updating the firmware
Page 8-2 F@ST 4310 Reference Manual
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited
You can update the firmware using one of the following methods:
• via HTTP
• via TR69 protocol
• automatically: the new firmware version download is performed automatically on starting up the router.
The download process is transparent on the router side: there is no LED blinking informing you of the
download process. So please make sure to wait for the router to reboot completly. The HTTP tool
configuration however shows the download status in the Supervision box.
HTTP update
You can download the new firmware to update your router using the Management menu in the HTTP
configuration tool (see section 5).
TR69 protocol
Operators can use "TR69" protocol to upgrade the router's firmware from their ACS server.
Important
Throughout the download procedure (up to five minutes), you must:
• not power down the router,
• not disconnect from the ADSL line.
Note
To check that the new version has been correctly downloaded, select in the HTTP
configuration tool the Device info menu; the Software version field displays the
last software version installed.

SAGEMCOM F@ST 4310 Specifications

General

Brand	SAGEMCOM
Model	F@ST 4310
Category	Network Router
Language	English