Annex E - Default configuration
Page E-2 F@ST 4310 Reference Manual
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited
This section details the values of the default parameters of your F@ST 4310 when it leaves the factory.
These default parameters can be modified by a particular preconfiguration of your F@ST 4310.
E.1 Default username and password
E.2 Default configuration for the local network(LAN)
The following table details the values of the principal LAN parameters of your router (LAN1 to LAN4):
E.3 Default configuration for the local wireless network (WLAN)
The following table supplies the principal default WLAN parameters of your router.
Username: admin
Password: see information given on the router sticker
Note
The Username and Password can be different according to the ISP (Internet
Service Provider).
LAN characteristics Value State
LAN1 IP address 192.168.1.1/24 Internet and HTTP configuration tool access
(bridged)
LAN2 IP address
LAN3 IP address
LAN4 IP address
BROADCAST, ARP, MULTICAST _ Activated
Router _ The LAN traffic is routed to your ISP
NAT/PAT _ Activated
Characteristics (Wi-Fi) Value
IP address 192.168.1.1/24
Enable Wireless Box checked
SSID see information given on the router sticker
Channel Auto
Network Authentication No
To Next Page
