SAGEMCOM F@ST 4310 - G.3 Pinouts of the LAN1, LAN2, LAN3 and LAN4 connectors

Annex G - Connector Technology
Page G-4 F@ST 4310 Reference Manual
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited
G.3 Pinouts of the LAN1, LAN2, LAN3 and LAN4 connectors
The Ethernet interface is connected to the equipment using a RJ45 fixed connector (8 pins).
Contact No Signal Meaning
1 TXD+ (+) Emission to terminal
2 TXD- (-) Emission to terminal
3 RXD+ (+) Reception of terminal
4 NC Not connected
5 NC Not connected
6 RXD- (-) Reception of terminal
7 NC Not connected
8 NC Not connected
Note
The Ethernet port is self-detecting. You can use either straight or crossed cables.
An emission or reception signal is detected automatically.