SAGEMCOM F@ST 4310 User Manual

5- Information / Configuration
Page 5-48 F@ST 4310 Reference Manual
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited
5.7.4 LAN
Object: This is used to configure the IP parameters for the local network (LAN).
• In the Advanced Setup menu, select LAN.
The following screen opens:
Field Action Default value
Groupname Select the required group. Default
IP Address Enter the address of your local network. 192.168.1.1
Subnet Mask Enter your network's subnet mask. 255.255.255.0
Enable IGMP
Snooping
Check this box to activate the IGMP (Internet Group
Management Protocol) protocol. This lets you manage the
declarations of belonging to one or more groups with Multicast
routers.
Not checked
Standard Mode
a
Check the box if you wish the IGMP snooping runs in normal
mode (transparency with IGMP frames).
Checked
Blocking Mode
a.
Check the box if you wish the IGMP snooping runs in blocking
mode (interception and removal of IGMP frames).
Not checked
Enable LAN side
firewall
Check the box to activate the LAN side firewall. Not checked
Disable DHCP
Server
Check this box to deactivate your router's DHCP server.
Note: You must configure your computer with the parameters
appropriate to your local network (IP address, subnet
mask and default gateway) as well as enter the primary
and secondary DNS server addresses.
Not checked

SAGEMCOM F@ST 4310 Specifications

General

Brand	SAGEMCOM
Model	F@ST 4310
Category	Network Router
Language	English