SAGEMCOM F@ST 4310 User Manual

5- Information / Configuration
Page 5-18 F@ST 4310 Reference Manual
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited
5.7.1 Layer2 Interface
Object: This menu is used to configure DSL interfaces.
This section contains the following menus:
• ATM Interface (see subsection 5.7.1.1)
• ETH Interface (see subsection 5.7.1.3)
5.7.1.1 ATM Interface
Object: This menu is used to configure DSL ATM interfaces.
• In the Advanced Setup menu, select Layer2 Interface then ATM Interface.
The following screen opens:
Field Meaning
Interface Name of the DSL ATM interface, allocated automatically.
Vpi Value of the VPI.
Vci Value of the VCI.
DSL Latency DSL Latency.
Category Type of service adapter to the traffic.
Link Type Protocol used in the DSL ATM interface.
Connection Mode Connection mode (Default mode, VLAN MUX Mode or MSC Mode).
IP Qos Status (Enabled or Disabled) of the Quality of Service function.

SAGEMCOM F@ST 4310 Specifications

General

Brand	SAGEMCOM
Model	F@ST 4310
Category	Network Router
Language	English