SAGEMCOM F@ST 4310 User Manual

5- Information / Configuration
Page 5-2 F@ST 4310 Reference Manual
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited
5.1 Accessing the welcome screen
If you are using your computer's Ethernet card to configure your router, connect it to an Ethernet port (LAN1
to LAN4).
Your router is then configured using a simple Web browser (e.g. Internet Explorer).
To access the configurer, proceed as follows:
To obtain the status of the DHCP server:
1. Click on Start > All Programs > F@ST 4310 > Configuration.
2. In the login screen that appears, enter your identification information.
By default, the identification information is:
3. Click on OK to validate.
Note
To access this screen, you must have configured one of your computer's interfaces
using the installation CD-ROM provided with your router (see section 3.).
Note
The router's DHCP server function is activated by default with an address range
defined as indicated in subsection.6.4.4.
Username: admin
Password: (see on the label)
Note
The equipment's IP address (192.168.1.1) appears in the header bar.

SAGEMCOM F@ST 4310 Specifications

General

Brand	SAGEMCOM
Model	F@ST 4310
Category	Network Router
Language	English