SAGEMCOM F@st Plug 502W User Manual

F@st Plug 502W PLC Wireless Router
- 30 -
DHCP
If you select DHCP, the PLC wireless router automatically obtains the IP address, subnet
mask, and IP address of the gateway from the ISP. If the ISP does not provide any IP
network parameters, please select this mode.
See the following figure:
The following table describes parameters in this page:
Field Description
Enable WAN Enable or disable the WAN connection of DHCP type.
Connection Type Select DHCP from the drop-down list.
Service Type
INTERNET: It is mainly used for the Internet service, for
example, surfing the Internet.
TR069 type: It is mainly used for the TR069 service, for
example, TR069 remote management.
TR069_INTERNET: a mixed type, which applies to both the
Internet and TR069 services.
Hostname Set the host name of local computer.
Vendor Class ID
Enter the vendor class ID. DHCP server assigns the IP
address to your router according to the vendor class ID.
MTU
Set the maximum transmission unit. It is 1500 bytes for most
Ethernet networks. But some ISPs may require smaller
MTUs. Do not modify the value of MTU size unless it is
necessary for your ISP connection.
Domain Name Server
Assignment
You can manually enter the IP address of domain name
server or let the DNS server automatically assign one to your
router.

SAGEMCOM F@st Plug 502W Specifications

General

Brand	SAGEMCOM
Model	F@st Plug 502W
Category	Wireless Router
Language	English