SAGEMCOM F@st Plug 502W User Manual

F@st Plug 502W PLC Wireless Router
- 34 -
Field Description
Domain Name Server
(Primary) IP
Enter the IP address of the primary DNS server. Domain
names should be resolved first by the primary DNS server.
Domain Name Server
(Secondary) IP
If the ISP provides another DNS server, enter the IP address
of the DNS server. If the primary DNS server fails to resolve
the domain name server, the secondary will resolve it.
LAN Port
The PLC wireless router supports 2 LAN ports, which can be
bound to different interfaces.
WLAN Port
The PLC wireless router supports 4 wireless WLAN ports,
which can be bound to different interfaces.
Enable VLAN Tagging
If you enable VLAN tagging and the VLAN value is not ‘0’,
message will carry the VLAN ID.
Bridge
In the Bridge mode, all physical ports and wireless interfaces co-exist in the virtual interfaces.
The following table describes parameters in this page:
Field Description
Enable WAN Enable or disable the WAN connection of bridge type.
Connection Type Select Bridge from the drop-down list.
Service Type You can only select Internet.
LAN Port
The PLC wireless router supports 2 LAN ports, which can be
bound to different interfaces.
WLAN Port
The PLC wireless router supports 1 WLAN ports, which can
be bound to different interfaces.
Enable VLAN Tagging
If you enable VLAN tagging and the VLAN value is not ‘0’,
message will carry the VLAN ID.
After setting the parameters, click Apply to save the settings.

SAGEMCOM F@st Plug 502W Specifications

General

Brand	SAGEMCOM
Model	F@st Plug 502W
Category	Wireless Router
Language	English