SAGEMCOM F@st Plug 502W User Manual

F@st Plug 502W PLC Wireless Router
- 62 -
Remote Device Configuration
The Remote Device Configuration allows you to view the configuration of the remote PLC
devices and to set the network passwords of the remote devices.
You can search current remote PLC devices by clicking the Scan button.
Select Enable from the drop-down list of Change Remote NetworkPwd to display the
following page.
You can set the passwords of remote PLC devices according to their MAC addresses and
DEKs (Device Equipment Key).
The following table describes parameters in this page:
Field Description
Device Name Enter the names of the remote devices.
Remote MAC Enter the MAC addresses of the remote devices.
Password (DEK)
When you set the parameters of the remote devices, you need to
enter this password for authentication.
Remote NetworkPwd Set the network passwords for the remote PLC devices.
Note
You can set up to 8 network passwords for the remote PLC devices.
You can access the Internet by network password synchronization. But network
passwords of the two devices for password synchronization must be the same, and
either of the PLC devices must be connected to the Internet.

SAGEMCOM F@st Plug 502W Specifications

General

Brand	SAGEMCOM
Model	F@st Plug 502W
Category	Wireless Router
Language	English