Salus AX10RF - AS20 WRF;BRF Thermostat with AX10 RF Receiver for Zone Valve Operation (RX2)

4.17
Section 4
AS20WRF/BRF Thermostat with AX10RF Receiver for
Zone Valve Operation (RX2)
Be sure the switch on the inside cover of the AX10RF Receiver has been congured to RX2, for zone
valve operation and the receiver has been wired as indicated in Section 3, Installation.
Each wireless system will support only one receiver in RX1 mode
and one in RX2 mode. These two components can be used
together to provide boiler switching and zone valve operation.
1. Open the SALUS Smart Home mobile application and select
the drop down menu from the upper right side of the screen select:
Equipment  All Equipment  Add New Equipment  Scan for Equipment
Auto Manual
On Off
The SG888ZB Gateway will begin ashing red while it is searching for the devices.
This will continue until the pair process is complete.
Device Pairing & Setup
with Internet Connection