Salus AX10RF - Resetting the AKL01;04;06 PRF Zone Pump or AKL08 RF Zone Valve Wiring Center

6.4
Resetting the AKL01/04/06PRF Zone Pump
or AKL08RF Zone Valve Wiring Center
without Internet Connection
1. Press and hold the Pair button for about 20
seconds until the G1/G2 lights start ashing.
After releasing the button, the network status light begins ashing
2. To complete the reset, cycle the power to the Wiring Center o for 10 seconds.
To reset the AKL Wiring Centers, locate
the Pair button on the top of the cabinet
near the cover screw on the right side.
with Internet Connection
To reset the AKL Wiring Centers, delete them from the SALUS Smart Home mobile application as follows:
The AKL Wiring Center WILL NOT OPERATE correctly until the power is cycled o and on.
7. Once the AKL Wiring Center is removed, be sure to cycle o the power for more than 10 seconds
to fully reset the unit.
1. Select the menu from the
upper right of the home screen.
2. Choose “Equipment” 3. Then choose, “All equipment”
4. Choose the appropriate
Wiring Center from the list.
5. Scroll to the bottom of
the screen.
6. Select “Remove Wiring Center”.
Resetting Factory Defaults
Section 6