SECTION VI ELECTRICAL SYSTEM
Front and rear working lights in cab roof
Bulbs: DIN 72601-H3 12V 55W -front (4) and rear (4)
To replace the bulbs, proceed as follows:
–
carefully clean the outside of the light unit to avoid the risk of dirt get-
ting on the reflector during bulb replacement.
–
using your hands only (tools could easily damage the components)
unscrew the two screws securing the rear cover and access the bulb
as follows:
–
detach the connector from the bulb base.
–
slightly rotate the spring clip that holds the bulb base in position, and
detach it from the reflector, disconnecting also the lead conected di-
rectly to the bulb.
WARNING: avoid touching the inner surface of the reflector. Make sure no
foreign material gets inside the reflector.
–
Insert the new bulb, engaging the locating tabs with the notches on the
reflector rim. Connect the bulb lead.
–
Push connector onto the terminals on the bulb base.
175
To Next Page
Loading...
Need help?
General
