Chapter 3. Installing the Product 3 - 43
Magnification
Specify the type of interpolation to use when resizing an image to print. Select from
Replicate, Bilinear, Cubic and None.
Border Density
Specify the border density of an image to print. Select Black or White.
Empty Density
Select the background color for the printed area. Select Black or White.
Min Density
Specify the minimum brightness of an image to print. If this option is not specified, the
default value is applied.
Max Density
Specify the maximum brightness of an image to print. If this option is not specified, the
default value is applied.
Medium Type
Specify the material type for the printout. Select from Paper, Clear Film, Blue Film,
Mammo Clear Film, and Mammo Blue Film.
Film Size
Specify the paper size. Select from 8 inch x 10 inch, 5 inch x 11 inch, 10 inch x 12 inch,
10 inch x 14 inch, 11 inch x 14 inch, 11 inch x 17 inch, 14 inch x 14 inch, 14 inch x 17
inch, 24cm x 24cm, 24cm x 30cm, A4 and A3.
Destination
Specify the paper pathway. Select Magazine or Processor.
Smoothing Type
This option is available only when Magnification is set to CUBIC. Enter a value for the
printer which is specified in the DICOM Conformance Statement.
Priority
Specify a priority for the print command. Select High, Med, or Low.
To Next Page