Chapter 3. Installing the Product 3 - 9
System Power
Boot up the system for use.
Turning the Power On
Press the On/Off button when the power is off. Booting begins, and the product logo appears on
the screen. When booting is completed, the 2D mode screen appears in End Exam status.
NOTE
If the power switch near the power connection port on the rear panel
of the product has been switched off, wait for 10 seconds before
turning on the product.
Do not press keyboard keys or buttons while booting is in progress.
Doing so may cause the system to malfunction.
If you turn on the power after turning it off suddenly, the system may
turn on and off momentarily. This is a characteristic of the Intel
®
PC
main board, and not a system error.
CAUTION
Make sure to connect the probes and peripheral devices that will be used
before powering on the system. If you attempt to connect them during
system use, it may lead to patient injury or irreparable damage to the
console.
CAUTION
Before starting the diagnosis, you must register the patient information.
To Next Page
Loading...