Sartorius Centrisart G-16 - Packaging; Transport Safety Device

To Next Page

To Previous Page

4 Storage and transport

Version 09/2015, Rev. 1.3 of 02/03/2017

Translation of the original operating manual, WZG6001-e150401

Pos: 83 /100 Sigma/11 0 BA Zentrifugen Sigma (Proje kte)/3-16L/0 40 Lagerung u nd Transport/040 -0040 Verpackung 3-16L @ 29\ mod_1405321600134 _68.do cx @ 197197 @ 2 @ 1

4.4 Packaging

The centrifuge is packaged in a slip-lid box.

Take off the lid.

Remove the box containing the accessories and the packaging material.

Remove the slip-lid box.

Lift the centrifuge upwards with a lifting device or with a sufficient number of

people to lift it safely. When lifting the centrifuge, always reach under the

centrifuge from the side.

CAUTION

The centrifuge weighs approx. 48 kg!

Retain the packaging for any possible future transport of the centrifuge.

Pos: 84 /010 Unive rsalmodule/ Leerzeile @ 0 \mod_1202116244 500_0.do cx @ 114 @ @ 1

Pos: 85 /100 Sigma/11 0 BA Zentrifugen Sigma (Proje kte)/3-16L/0 40 Lagerung u nd Transport/040 -0050 Transports icherung 3-16L - Überschrift @ 29\mod_14053 21600880_68.do cx @ 197211 @ 2 @ 1

4.5 Transport safety device

Pos: 86 /100 Sigma/11 0 BA Zentrifugen Sigma (Proje kte)/3-16L/0 40 Lagerung u nd Transport/040 -0051 Transports icherung 3-16L - Text @ 36\ mod_1434605535989 _68.docx @ 263 887 @ @ 1

The transport safety device consists of a foamed plastic piece in the rotor chamber.

CAUTION

The transport safety device must be removed prior to start-up because the screws

lock the motor bearings!

Removal

Open the lid by pressing the lid key. If the centrifuge is not connected to the

power supply, use the emergency release of the lid (see chapter 7.1.1 -

"Emergency lid release").

Remove the foamed plastic piece (see figure, item 1) from the rotor chamber,

by lifting it carefully on one side.

Fig. 4: Removal of the transport safety device

Retain the transport safety device for the possibility of the return of the