Version 09/2015, Rev. 1.3 of 02/03/2017
Translation of the original operating manual, WZG6001-e150401
Pos: 105 /100 Sigma/1 00 BA Zentr ifugen Sigma (Sta ndardmodule)/0 60 Betrieb_Spin control L+S/060 -0020-0019 Ei nsetzen von Rotoren und Zubehör (außer 8 K)------------- --------------- ---- @ 27\mod_14 05319204492_ 68.docx @ 192 493 @ 3 @ 1
6.2.2 Installation of rotors and accessories
Pos: 106 /100 Sigma/1 10 BA Zentr ifugen Sigma (Proje kte)/3-16L/ 060 Betrie b/060-0020-0020-0010 Einsetzen des Rotors 3-16L @ 29\mod_1405321 629853_68. docx @ 197253 @ 4 @ 1
6.2.2.1 Installation of the rotor
Open the centrifuge lid by pressing the lid key.
Unscrew the rotor tie-down screw from the motor shaft (counter-clockwise).
Lower the rotor with its central bore straight down onto the motor shaft.
Tighten the rotor tie-down screw clockwise with the supplied rotor wrench
with 7.5 Nm. In doing so, hold the rotor at its outer rim.
Once a day or after 20 cycles, the rotor tie-down screw must be loosened by some
turns, and the rotor must be lifted and fastened again. This ensures a proper
connection between the rotor and the motor shaft.
When using rotors for microtiter plate formats:
Ensure that the plate holders are inserted together with the plates into the
buckets.
The lid screw serves for the fastening of the lid onto the rotor only, not for the
fastening of the rotor onto the motor shaft.
Follow the safety instructions and hazard warnings (see chapter 3 - "Safety")!
Pos: 107 /010 Unive rsalmodule/ Leerzeile @ 0 \mod_120211624 4500_0.do cx @ 114 @ @ 1
Pos: 108 /100 Sigma/1 10 BA Zentr ifugen Sigma (Proje kte)/3-16L/060 Betrie b/060-0020-0020-0020 Einsetzen von W inkelr otoren mit hermet isch verschließbarem De ckel @ 29 \mod_140532 1630505_68.do cx @ 197267 @ 4 @ 1
6.2.2.2 Installation of angle rotors with a hermetically sealed lid
Screw the rotor cover onto the rotor and tighten it.
Lower the rotor with the cover onto the motor shaft .
Insert the rotor tie-down screw into the motor shaft. Tighten the rotor tie-
down screw with 7.5 Nm using the supplied rotor wrench so that the spring
washer assembly is compressed tightly.
The rotor can also be used without a cover.
The rotors can be installed or removed with a closed lid after loosening the
rotor tie-down screw.
Follow the safety instructions and hazard warnings (see chapter 3 - "Safety")!
To Next Page
Loading...
