Sartorius Centrisart G-16 - Table of Error Codes

7 Malfunctions and error correction
Version 09/2015, Rev. 1.3 of 02/03/2017
43
Translation of the original operating manual, WZG6001-e150401
Pos: 160 /100 Sigma/1 01 BA Zentr ifugen Sartorius (Sta ndardmodule) /070 Störungen u nd Fehlersuche /070-0020 Tabelle der Fehler meldungen Sart orius @ 36\ mod_1431074359973 _68.do cx @ 261984 @ 2 @ 1

7.2 Table of error codes
Error no.
Kind of error
Measures
Note
1-9
System error
Allow to slow down
Power off/on
All these errors stop the
centrifuge or cause it to
decelerate brakeless
10-19
Speedometer error
Allow to slow down
Power off/on
20-29
Motor error
Power off
Ensure ventilation
30-39
EEPROM error
Allow to slow down
Power off/on
With error 34, 35, and 36, the
centrifuge will stop;
with error 37 and 38 only an
error message will be given
40-45
Temperature error
(only for refrigerated
centrifuges)
Allow to slow down
Power off
Allow to cool down
Provide better ventilation (only air cooled
centrifuges)
Provide sufficient water throughput (only
water cooled centrifuges)
46-49
Imbalance error
Allow to slow down
Power off
Eliminate the imbalance
50-59
Lid error
Press lid key
Close lid
Remove foreign matter from the opening of
the lid lock device
With error 50 and 51, the
centrifuge will stop
60-69
Process error
Allow to slow down
Power off/on
With error 60 message
"power failure during run",
with error 61, the message
"stop after power on"
70-79
Communication error
Allow to slow down
Power off/on
80-89
Parameter error
Power off
Allow to cool down
Provide for better ventilation
With error 83, error message
only
90-99
Other errors
Check connections
Provide sufficient water throughput (only
water cooled centrifuges)
NOTE
If it is impossible to eliminate the errors, contact the service!
Please find the corresponding contact data for your region on our website
www.sartorius.com.
Pos: 161 /010 Unive rsalmodule/Seite nwechsel @ 0\m od_12021162 44312_0.docx @ 105 @ @ 1