Sartorius Centrisart G-16 - 6 Using the Centrifuge; Initial Start-Up; Switching the Centrifuge on; Opening and Closing the Lid

6 Using the centrifuge
26
Version 09/2015, Rev. 1.3 of 02/03/2017
Translation of the original operating manual, WZG6001-e150401
Pos: 98 /100 Sigma/10 0 BA Zentrifugen Sigma (Sta ndardmodule)/06 0 Betrieb_Spin control L+S/060 Betr ieb==== ===== ============= ====== ============= @ 27\mod_14053191988 95_68.docx @ 1 92423 @ 1 @ 1

6 Using the centrifuge
Pos: 99 /100 Sigma/10 0 BA Zentrifugen Sigma (Sta ndardmodule)/06 0 Betrieb_Spin control L+S/060 -0010 Erste Inbetriebnahme @ 27\mod_1405319 200130_68.do cx @ 192437 @ 2 @ 1

6.1 Initial start-up
DANGER
Before the initial start-up, please ensure that your centrifuge is properly set up
and installed (see chapter 5 - "Set-up and connection").
Pos: 100 /010 Unive rsalmodule/ Leerzeile @ 0 \mod_120211624 4500_0.do cx @ 114 @ @ 1
Pos: 101 /100 Sigma/1 00 BA Zentr ifugen Sigma (Sta ndardmodule)/0 60 Betrieb_Spin control L+S/060 -0020 Eins chalten (außer 6-1 6HS) @ 27 \mod_140531920134 0_68.docx @ 1 92451 @ 2 @ 1

6.2 Switching the centrifuge on
Press the mains power switch.
The display then illuminates. The centrifuge is ready for operation.
Pos: 102 /010 Unive rsalmodule/ Leerzeile @ 0 \mod_120211624 4500_0.do cx @ 114 @ @ 1
Pos: 103 /100 Sigma/1 00 BA Zentr ifugen Sigma (Sta ndardmodule)/0 60 Betrieb_Spin control L+S/060 -0020-0010 Öff nen und Sc hließen des Decke ls - 1 Schloss @ 2 7\mod_140 5319202508_68. docx @ 1924 65 @ 3 @ 1

6.2.1 Opening and closing the lid
The lid can be opened if the centrifuge is at a standstill and if the lid key is
illuminated.
Press the lid key in order to open the lid.
The centrifuge cannot be started if the lid is opened.
To close, press with both hands slightly on the lid until the electrical lock is
locked.
WARNING
Do not place your fingers between the lid and the housing when closing the lid.
Risk of crushing!
Pos: 104 /010 Unive rsalmodule/Seite nwechsel @ 0\mod_12021162 44312_0.docx @ 105 @ @ 1