Version 09/2015, Rev. 1.3 of 02/03/2017
Translation of the original operating manual, WZG6001-e150401
6.3.2.10 Sound signal ("Buzzer")
This function is used to set an acoustic warning signal that sounds at the end of the
centrifugation run and also in the event of an imbalance or error message.
In order to activate the sound signal:
Select the "Buzzer" symbol with the cursor and confirm the selection. The
symbol and the bar under the symbol start to flash.
Activate the function by turning the function knob. The symbol remains
displayed in a permanent manner and the bar continues to flash.
Turning the function knob further will deactivate the function. In this case, the
symbol disappears but the bar continues to flash.
Press the function knob in order to activate the desired setting. The bar remains
visible as long as the cursor is placed over the symbol.
Fig. 18
Pos: 139 /010 Unive rsalmodule/Seite nwechsel @ 0\m od_12021162 44312_0.docx @ 105 @ @ 1
Pos: 140 /100 Sigma/1 01 BA Zentr ifugen Sartorius (Sta ndardmodule) /060 Betrie b/Spincontrol L/060 -0030-0020-01 21 Progra mmsperre - ohne Temp Sartorius @ 37\mod_143737 4460025_68.do cx @ 273040 @ 4 @ 1
6.3.2.11 Program lock ("ProgLock")
When the program lock is active, it is impossible to save any new programs. In this
case, the function "save program" is disabled.
In order to activate the program lock:
Select the "ProgLock" symbol with the cursor and confirm the selection. The
symbol and the bar under the symbol start to flash.
Activate the function by turning the function knob. The symbol remains
displayed in a permanent manner and the bar continues to flash.
Turning the function knob further will deactivate the function. In this case, the
symbol disappears but the bar continues to flash.
Press the function knob in order to activate the desired setting. The bar remains
visible as long as the cursor is placed over the symbol.
Fig. 19:
Pos: 141 /010 Unive rsalmodule/Seite nwechsel @ 0\m od_12021162 44312_0.docx @ 105 @ @ 1
To Next Page
Loading...
