Version 09/2015, Rev. 1.3 of 02/03/2017
Translation of the original operating manual, WZG6001-e150401
Runtime as of the set speed
If the runtime is to be counted as of the moment when the set speed is reached,
the symbol (see the illustration) behind the set speed value must be activated:
Select the clock symbol with the cursor and confirm the selection. The symbol
and the bar under the symbol start to flash.
Activate the function by turning the function knob. The symbol remains
displayed in a permanent manner and the bar continues to flash.
Further turning of the function knob will deactivate the function. In this case,
the symbol disappears but the bar continues to flash.
Press the function knob in order to activate the desired setting. The bar remains
visible as long as the cursor is placed on the symbol.
Fig. 12: The function "Runtime as of the set speed" is activated
Continuous run
During the continuous run, the runtime of the centrifuge is unlimited and must be
stopped manually. The centrifuge accelerates during the continuous run until the
set speed is reached.
Select the "Time" field and press the function knob. The indication "set" flashes
in the activated status.
Turn the function knob from the time 0:00:10 anti-clockwise or from the time
99:59:59 clockwise. The indication "Cont" will be displayed in the "Time" field.
During the centrifugation run, the elapsed time will be displayed.
Deactivate the continuous run by pressing the stop key or by entering a specific
runtime.
Fig. 13:
To Next Page
Loading...
