Configuring the Interface Settings Using the All-In-One Tool
118
The following explanation uses an example in which the printer and computer are connected with a
USB cable.
• The factory settings of the wireless LAN interfaces are as follows:
Wireless Mode Ad-hoc
Communication Channel 6
SSID SATO_PRINTER
Security None
IP Address 0.0.0.0
Subnet Mask 255.255.255.0
Gateway Address 0.0.0.0
• When you use the wireless LAN connection, the communication condition settings
must be configured according to your network environment. For details, consult with
the network administrator.
1. Connect the USB cable to the printer, and power on the printer.
• If the printer is turned on without installing the printer driver, Windows' Plug & Play
runs.
◦ For Windows 7/8/8.1/Server 2012, the printer will be added to [Devices and Printers]
as an unspecified device.
◦ If a message is displayed that indicates new hardware is detected on Windows Vista/
Server 2008, cancel it.
2. Activate [SATO] > [SATO All-In-One Application] on the computer.