SATO CL4NX - Page 347

347
Interface
Set the RS-232C interface usage.
Baudrate
Set the communication speed.
Parameters
Set the data parameters.
Flow Control
Set the communication protocol.
BCC
Set the BCC check function.
◦ Appears only if you have selected [STATUS5] in the [Flow Control] menu.
• When [Interface] is set to [RS-232C Reader], you cannot change [Baudrate],
[Parameters], [Flow Control] or [BCC].
[Interface]
Set the RS-232C interface usage.
The options are as follows:
RS-232C
Use the RS-232C interface for communicating with computers.
RS-232C Reader
Select this when you connect the KEYENCE barcode checkers for the barcode check function.
• A message prompting you to restart the printer will appear on the Online/Offline screen
if you have made any changes. In such a case, reboot the printer to apply the settings.