SATO CL4NX - Page 579

579
Operation 48: RFID Write with Cutter Mode and Backfeed After Printing (Tag Offset >
0) (CL4NX only)
When the cutter mode is selected, backfeed after printing is automatically set. The label backfeeds
after the cut and stops at the print head position.
*1 Because the EPC code read, RFID read [DC2]PJ, UID/EPC/IDm printing <TU>, and UID/EPC/IDm
return <RU> commands acquire the information at this tag position, do not use them if the Tag Offset
is set to other than an initial value.
*2 The EPC code write <IP0> and RFID write <RK> commands write the data at this tag position.