SATO CL608 - Page 128

PN 9001024
Rev. B Jan. 2000
Page 6-31
SATO CL608 & CL612 SERVICE MANUAL
SECTION 6 – Replacement Procedures
Fig. 6-63
REMOVE (3) SCREWS
TO DETACH THE RAMP
PLATE FROM THE
RAMP FRAME
Fig. 6-62
RAMP FRAME
RAMP PLATE
REMOVE (3) SCREWS
TO DETACH THE RAMP
PLATE FROM THE
BACK PLATE
6-11 Replacing the Paper End Switch (Micro-Switch) and the
Bottom Half of the Notch/Gap and Eye-Mark Sensors
Fig. 6-64
FOR UNITS WITH DISPENSER
OPTION INSTALLED, THIS IDLER
AND GEAR MUST BE REMOVED
FOR ACCESS TO THE 3RD
SCREW (SCREW IS UNDER
GEAR) WHICH SECURES THE
RAMP TO THE FRAME