SATO CL608 - Page 129

PN 9001024
Rev. B Jan. 2000
Page 6-32
SATO CL608 & CL612 SERVICE MANUAL
SECTION 6 – Replacement Procedures
6-11 Replacing the Paper End Switch (Micro-Switch) and the
Bottom Half of the Notch/Gap and Eye-Mark Sensors
WIGGLE THE RAMP
PLATE FREE FROM
THE PRINTER
Fig. 6-68
Fig. 6-66
Fig. 6-65
REMOVE 3RD SCREW
TO DETACH RAMP
FROM FRAME
FOR UNITS WITH DISPENSER
OPTION INSTALLED, THIS IDLER
AND GEAR MUST BE REMOVED
FOR ACCESS TO THE 3RD
SCREW (SCREW IS UNDER
GEAR) WHICH SECURES THE
RAMP TO THE FRAME
Fig. 6-67
DETACH
CONNECTORS
FROM SEN1 &
SEN7