SATO CL608 - Page 171

PN 9001024
Rev. B Jan. 2000
Page 9-19
SECTION 9 – Addendum
SATO CL608 & CL612 SERVICE MANUAL
Serial No. 81199999 and below
9-9 Replacing the Paper End Switch (Micro-Switch) and the
Bottom Half of the Notch/Gap and Eye-Mark Sensors
CL608 & CL612
Serial #8199999 and below
Fig. 9-27
FOR UNITS WITH DISPENSER
OPTION INSTALLED, THIS IDLER
AND GEAR MUST BE REMOVED
FOR ACCESS TO THE 3RD
SCREW (SCREW IS UNDER
GEAR) WHICH SECURES THE
RAMP TO THE FRAME
RAISE THE
ACCESS DOOR
Fig. 9-24
REMOVE (3) SCREWS TO
DETACH THE RAMP PLATE
FROM THE RAMP FRAME
Fig. 9-26
REMOVE (3) SCREWS
TO DETACH THE RAMP
PLATE FROM THE
BACK PLATE
Fig. 9-25
RAMP FRAME
RAMP PLATE