PN 9001024
Rev. B Jan. 2000
Page 9-20
SECTION 9 – Addendum
SATO CL608 & CL612 SERVICE MANUAL
Serial No. 81199999 and below
9-9 Replacing the Paper End Switch (Micro-Switch) and the
Bottom Half of the Notch/Gap and Eye-Mark Sensors
CL608 & CL612
Serial #8199999 and below
Fig. 9-29
WIGGLE THE RAMP
PLATE FREE FROM
THE PRINTER
Fig. 9-31
Fig. 9-28
Fig. 9-30
REMOVE 3RD SCREW
TO DETACH RAMP
FROM FRAME
DETACH
CONNECTORS
FROM SEN1 &
SEN7
FOR UNITS WITH DISPENSER
OPTION INSTALLED, THIS IDLER
AND GEAR MUST BE REMOVED
FOR ACCESS TO THE 3RD
SCREW (SCREW IS UNDER
GEAR) WHICH SECURES THE
RAMP TO THE FRAME
To Next Page
Loading...
