SATO CL608 - Page 27

PN 9001024
Rev. B Jan. 2000
SECTION 2 – Configuration
Page 2-4
SATO CL608 & CL612 SERVICE MANUAL
If the custom Protocol Command codes are incorrect or if the printer does not respond to
commands using the custom set, the Alternate Protocol Control Codes can be restored by
the following procedure:
STEP PROCEDURE
1. Turn the printer OFF.
2. Place DIP switch DSW2-7 in the ON position.
3. Turn power on while simultaneously pressing the FEED and LINE
switches.
Selecting Protocol Control Codes (Cont.)
Download Command Structure
The command for downloading a new set of Protocol Command Codes takes the form of
<ESC>LD,a,b,c,d,e,f,g,h,i. The parameters specified for a through i can be transmitted in
either ASCII characters or hex notation, allowing a complete 128 character (except for the ,)
set to be used for selecting the custom code.
RETEMARAPGNITTESDRADNATS
GNITTESETANRETLA
)TLUAFED(
aXTS{
bXTE}
cCSE^
dQNE@
eNAC!
f~ ~
gENILFFO]
)ENILNOotuA(hONSEY=0
ON=1
)hsalSoreZ(ioNSEY=0
ON=1