SATO CL608 - Page 28

PN 9001024
Rev. B Jan. 2000
Page 2-5
SATO CL608 & CL612 SERVICE MANUAL
SECTION 2 – Configuration
STEP PROCEDURE
1. Reset the printer to the default settings using the Reset
procedure.
2. Place DIP switch DSW2-7 in the ON position.
For printers that do not have an LCD panel, you will hear a single
beep signifying the printer is in the USER DOWNLOAD mode.
4. Set DIP switch DSW2-7 in the position to accept the Protocol
Control codes to be used for downloading (i.e. DSW2-7 = OFF
for Standard codes and DSW2-7 =ON to use the Alternate set).
5. Press the LINE key to place the printer in the ON-LINE mode.
The printer is ready to receive the download command data
stream.
6. After the command has been sent, the unit will beep and print a
status label. If it does not beep and print the label, the printer
did not accept the data.
7. If the printer does not beep and print a setting label, turn the
printer off, check your download command stream for errors and
start the download process over at step 1.
8. If custom codes are correct, press the FEED key to accept them
and terminate the download process. If they are incorrect, turn
the unit off without pressing the FEED key and begin the
download process again at step 1.
Selecting Protocol Control Codes (Cont.)
Download Procedure
3. Turn power ON while simultaneously pressing the LINE switch.
This places the printer in the USER DOWNLOAD mode as signified
by USER DOWNLOAD displayed on the LCD panel.