SATO CL608 - Page 29

PN 9001024
Rev. B Jan. 2000
SECTION 2 – Configuration
Page 2-6
SATO CL608 & CL612 SERVICE MANUAL
M84XX Compatibility (DS2-8)
For emulating M8400 software. Should be used only if problems are encountered when
using existing M8400 software.
DSW2-8 SETTING
OFF OFF (Normal
Operation)
ON
M-8400
Compatibility
12 345678
ON
OFF
DSW2
DSW3-1 DSW3-2 SETTING
OFF OFF Batch/Continuous
OFF ON Tear Off
ON OFF Cutter
ON ON Dispenser
12 345678
ON
OFF
DSW3
LORTNOC
RETCARAHC
DRADNATS
7-2WSD
DRADNATS-NON
7-2WSD
NOITPIRCSED
XTSxeH20{=xeHB7ataDfotratS
XTExeH30}=xeHD7ataDfodnE
CSExeHB1^=xeHE5wollofotedocdnammoC
lluNxeHE7~=xeHE7dnammocrettuC
QNExeH50@=xeH04edommoC-iB,sutatsretnirpteG
naCxeH81!=xeH12edommoC-iB,bojtnirplecnaC
eniL-ffOxeH04]=xeHD5eniL-ffOretnirpekaT
Selecting Protocol Control Codes (Cont.)
Mode Selection (DSW3-1 and DSW3-2)
Selects the operating mode of the printer. Batch/Continuous disables the label sensors.