SATO CL608 - Page 30

PN 9001024
Rev. B Jan. 2000
Page 2-7
SATO CL608 & CL612 SERVICE MANUAL
SECTION 2 – Configuration
Label Sensor Selection (DSW3-3)
Enables or disables the Label Sensor. If the Sensor is enabled, it will detect the edge of the
label and position it automatically. If it is disabled, the positioning must be under software
control using Line Feed commands.
Back Feed Selection (DSW3-4 )
When Back-Feed is enabled, the printer will position the label for dispensing/cutting and
retract it to the correct print position before printing the next label.
External Signal Interface
The EXT connector on the printer rear panel is intended for use with the external printer
accessories such as label rewinders or applicators. The 14-pin Centronics type connector
provides a choice of four different output signals along with various error conditions.
Print Start Signal Selection (DSW3-5)
NOTE: This switch must be in the ON position if a VeriScan is used to control the printer via
the EXT connector.
DSW3-3 SETTING
OFF Sensor Used
ON Not Used
12 345678
ON
OFF
DSW3
DSW3-4 SETTING
OFF Disabled
ON Enabled
12 345678
ON
OFF
DSW3
DSW3-5 SETTING
OFF Disabled
ON Enabled
12 345678
ON
OFF
DSW3
4-3WSDGNITTES
NOdelbasiD
FFOdelbanE
OFF
ON