SBM SB-3000 - 9.4.0. MR Calibration

102
9.4.0. MR Calibration
This MR Calibration is for MR Sensors.
<MR CALIBRATION SHEET: Real Banknote ‘US$ 1’ >
[Procedure]
[1] Touch on MR Calibration MENU
[SEVICE MENU _ Machine management/
Calibration/ MR calibration]
[2] Place 1 ~ 5 bills of US$ 1 on the hopper with
the same direction as shown on the right figure
(The condition of US$1 should be good!!)
[3] Check if MR Calibration result is “OK” or “NG”
[4] If it is “NG”, repeat placing the note several times until “OK” shows up on the display.
(FIG 5-03)
(FIG 9-04)
(FIG 9-05)
(FIG 5-02)