4.4.0. COUNTING
In AUTO mode, SB-3000 starts to count the bill automatically as it detects the existence of the banknotes
in the hopper. In MANUAL mode, the machine will start to count the banknotes only if the banknotes are
placed into the hopper and START key is pressed. While counting, the machine will display the number of
the banknotes on LCD display and it stops working when it meets the conditions described as below;
No bills in the hopper
Stacker is full.
Rejecter is full.
The number of the bills counted is the same as the batch number to be set in BATCH function.
Errors have occurred.
If an error is occurred during operation and the machine stops, then an error message will be displayed.
To clear the error, press “C” key. The machine will try to solve the problem automatically, but if it fails to
clear a jam or there are some other mechanical errors, open the rear door A (rear top) or rear door B (rear
middle or rear bottom) and get rid of jammed banknotes and close the cover correctly. Then the machine
can clear error message automatically.
(Stop in operation)
Press [START/STOP] button to stop operation for an instant while the machine is operating.
If you want to count continuously again, press [START/STOP] button.
Stop in operation
Please START button to stop operation while the machine is counting.
If you want to count continuously again, press [START/STOP] button.
To Next Page
Loading...