3 Packaging, transport and storage
Operating instructions for actuators type AB with SMARTCON control unit
OM-ENGLISH-CSC-V2.08-2019.11.07
2.10 Information notice (tag)
Each actuator is provided with a bilingual tag containing key information, which is attached to the handwheel
after final inspection. This tag also shows the internal commission registration number (see Figure 10)
Figure 10: tag
3 Packaging, transport and storage
You can order the actuators to be delivered with or without packing. Special packing requirements must be
specified along with your order. Use extreme caution when unpacking or repacking the actuator.
Use soft belts for hoisting equipment. Do not attach hoisting belts to the handwheel.
3.1 General
The indicator lids of all actuators contain a minimum of 5 g of silica gel ex factory.
WARNING! Prior to start-up of the actuator (refer to section 5, page 12) all of the silica gel
must be removed!
3.2 Storage
CAUTION
Observing the following precautions will help to avoid damage when storing actuators:
8
To Next Page
Loading...
