Celsius. An alert will be raised if the temperature of any connected temperature sensor exceeds
the set value.
It can be disabled by setting it to ‘0’.
A feature allowing the use of longer names for inputs, outlets and sensors when viewing the web
interface or using SNMP when it is enabled. This setting also affects the names shown on the LCD
display.
● limited to 18 characters
● setting is valid for SNMP, the web interface and the LCD display
● for API and Modbus, both the original and extended name registers can be used
simultaneously and independently of each other.
● when the device is configured in bridge mode, all connected devices should support the
extended name feature to work properly.
When using both Classic and ethernet PDUs in a databus, the extended name suport may lead to
conflicting situations.
To Next Page
Loading...