Maintenance
9. Remove the jaws(2) from the housing(1).
10. Remove screws(117) and take cylinder piston(7) out of the
drive housing(3).
11. Remove screw(121), remove cover(12) and take pinion(6) out
of the drive housing(3).
12. Remove screw(118), remove driver(8).
13. Press the gear rack(5) into the drive housing(3) and remove it
from the other side.
14. Remove old seals(14,16,17,110,111,112 and 113).
Install new seals
Note: When installing, secure all screws with medium-strength
threadlocker and observe the tightening torque, }7.6 [
/
56].
1. Clean guiding areas.
2. Attach new seals(110,111,112) from the seal kit.
3. Re-lubricate guiding areas and serration.
4. Press the gear rack(5) into the drive housing(3).
IMPORTANT!Observe the installation position and direction
of the gear racks(5) in the drive housing(3).
5. Press the driver(8) into the gear rack(5) and secure with the
screw(118).
6. Push the driver(8) together and press the pinion(6) into the
drive housing(3).
7. Secure the cover(12) with the screws(121).
8. Insert the seals(113) into the cylinder piston(7).
9. Insert the cylinder piston(7) into the drive housing(3).
10. Tighten screws(117).
11. Insert jaws(2) into the guide housing(1).
IMPORTANT!Observe the installation position of the jaws(2)
in the housing(1).
12. Insert the magnet holder(31) into the jaw(2) and fasten it
with the screw(119).
13. Insert the flat gasket(16).
14. Secure the cover(11) with the screws(116).
15. Insert the gaskets(14).
16. Press base jaws(4) into jaws(2) and secure with screw(13).
17. Assemble the guide housing(1) and drive housing(3) and
secure with the screws(115).
18. Insert the flat gasket(17) into the cover(9).
19. Secure the cover(9) with the screws(120).
20. Mount product onto the system/machine.
21. Connect all compressed air lines.
4902.00 | PGL-plus-P | Assembly- and Operating Manual | en | 1508050
To Next Page
Loading...
