SCHUNK PGL-plus-P - UKCA Declaration of Incorporation

UKCA declaration of incorporation
62 02.00 | PGL-plus-P | Assembly- and Operating Manual | en | 1508050
10 UKCA declaration of incorporation
in accordance with the Supply of Machinery (Safety) Regulations 2008.
Manufacturer/
Distributor
SCHUNK Intec Limited
Clamping and gripping technology
3 Drakes Mews, Crownhill
MK8 0ER Milton Keynes
We hereby declare that on the date of the declaration the following partly completed
machine complied with all basic safety and health regulations found in the
"Supply of Machinery (Safety) Regulations 2008".
The declaration shall be rendered invalid if modifications are made to the product.
Product designation: 2-Finger Parallel Gripper / PGL-plus-P / pneumatic
The partly completed machine may not be put into operation until it has been confirmed
that the machine into which the partly completed machine is to be installed complies with
the provisions of the "Supply of Machinery (Safety) Regulations 2008".
Applied harmonized standards, especially:
EN ISO 12100:2010 Safety of machinery - General principles for design -
Risk assessment and risk reduction
EN ISO 14118:2018 Safety of Machinery - Prevention of unexpected start-up
The manufacturer agrees to forward on demand the relevant technical documentation for
the partly completed machinery in electronic form to national authorities.
The relevant technical documentation according to AnnexVII, Part B, belonging to the
partly completed machinery, has been created.
Person authorized to compile the technical documentation:
Marcel Machado, address: refer to manufacturer's address
Lauffen/Neckar, October 2022
p.p. Ralf Winkler;
Head of Technology & Engineering,
Mechanics Gripping Systems