SCHUNK PGL-plus-P - Page 51

Maintenance
2. Remove product from the system/machine.
3. CAUTION!Cover(25) is under spring tension. Carefully
remove the screws(128, 129). Remove cover(25) and
spring(23).
4. Remove screws(115).
5. Pull guide housing(1) and drive housing(3) apart.
6. Mark the installation position of the jaws(2) on the guide
housing(1).
7. Remove screws(13) and take out base jaws(4).
8. Remove screws(116) and take off the cover(11).
9. Remove screws(119) and take off the magnet holder(11).
10. Remove the jaws(2) from the housing(1).
11. Remove screws(130) and take cylinder piston(26) out of the
drive housing(3).
12. Remove screw(121), remove cover(12) and take pinion(6) out
of the drive housing(3).
13. Remove screw(118), remove driver(8).
14. Press the gear rack(5) into the drive housing(3) and remove it
from the other side.
15. Remove old seals(14,16,17,110,111,112 and 113).
Install new seals
Note: When installing, secure all screws with medium-strength
threadlocker and observe the tightening torque, }7.6 [
/
56].
1. Clean guiding areas.
2. Attach new seals(110,111,112) from the seal kit.
3. Re-lubricate guiding areas and serration.
4. Press the gear rack(5) into the drive housing(3).
IMPORTANT!Observe the installation position and direction
of the gear racks(5) in the drive housing(3).
5. Press the driver(8) into the gear rack(5) and secure with the
screw(118).
6. Push the driver(8) together and press the pinion(6) into the
drive housing(3).
7. Secure the cover(12) with the screws(121).
8. Insert the seals(113) into the cylinder piston(26).
9. Insert the cylinder piston(26) into the drive housing(3).
10. Tighten screws(130).
11. Insert jaws(2) into the guide housing(1).
IMPORTANT!Observe the installation position of the jaws(2)
in the housing(1).
12. Insert the magnet holder(31) into the jaw(2) and fasten it
with the screw(119).
13. Insert the flat gasket(16).
5102.00 | PGL-plus-P | Assembly- and Operating Manual | en | 1508050