Maintenance
54 02.00 | PGL-plus-P | Assembly- and Operating Manual | en | 1508050
6. Push the driver(8) together and press the pinion(6) into the
drive housing(3).
7. Secure the cover(12) with the screws(121).
8. Insert the seal(113) into the cylinder piston(27).
9. Tighten the screw(131).
10. Insert jaws(2) into the guide housing(1).
IMPORTANT!Observe the installation position of the jaws(2)
in the housing(1).
11. Insert the magnet holder(31) into the jaw(2) and fasten it
with the screw(119).
12. Insert the flat gasket(16).
13. Secure the cover(11) with the screws(116).
14. Insert the gaskets(14).
15. Press base jaws(4) into jaws(2) and secure with screw(13).
16. Assemble the guide housing(1) and drive housing(3) and
secure with the screws(115).
17. Insert the flat gasket(17) into the cover(25).
18. CAUTION!The components are under spring tension! Place
the spring(24) in the cylinder piston(27) and push it carefully
in the direction of the drive housing(3). Tighten the
screw(131).
19. Secure the cover(25) with screws(128, 129).
20. Mount product onto the system/machine.
21. Connect all compressed air lines.
To Next Page
Loading...
