SciCan Statim 5000 - External Serial Printers (for use on Rev. 7.x controller boards ONLY); Recommended Printers for Statims with Revision 7 Controller Boards

Page 249
STAT IM 2000/2000S Service Guide
96-106775 Rev 5.0
12. Printer and Data Logger
STATIM 5000/5000S/5000 G4 Service Guide
External Serial Printers (for use on Rev. 7.x controller boards ONLY)
When fitting an external printer to a STATim unit it is recommended
that a ‘till roll’, ‘point of sale’ or ‘receipt’ style printer is used similar to
the example shown:
Note that these printers are NOT sold by Scican and should be
purchased in the relevant territory by the user or the dealer for fitting.
They are readily available (typically over the internet).
These printers do not normally come with a cable as standard and a
Serial Null Modem Cable DB9F – DB25M will be required.
Recommended Printers for STATIMs with Revision 7
Controller Boards
The following printers have been tested by SciCan and are recommended for use as an external
printer for STATim 5000 units with Rev. 7 boards. They may be purchased from your local
computer store or from an online supplier.