TROUBLESHOOTING GUIDELINES
iBR WILL NOT RETURN TO NEUTRAL POSITION (IBR INDICATOR LIGHT ON)
1. iBR jammed with debris.
– Clean and check for damage intheiBRgateandnozzlearea.
2. iBR system malfunction.
– Remove tether cord, wait four minutes, reinstall key and check iBR light to
ensure fault is cleared.
– Refer to an authorized Sea-Doo dealer if fault persists or reoccurs frequently.
iBR WILL NOT RETURN TO NEUTRAL POSITION (IBR INDICATOR LIGHT OFF)
1. Throttle lever not fully released during operation.
– Release throttle lever fully to ensure iBR gate returns to neutral.
2. Throttle lever does not fully return to null when released.
– Refer to an authorized Sea-Doo dealer.
ABNORMAL NOISE FROM PROPULSION SYSTEM
1. Weeds or debris jammed around impeller.
– Clean. Refer to JET PUMP WATER INTAKE AND IMPELLER CLEANING in
SPECIAL PROCEDURES section.
– Ceck for damage.
2. Damaged impeller shaft or drive shaft.
– Refer to an authorized Sea-Doo dealer.
3. Water intrusion in jet pump causing bearing seizure.
– Refer to an authorized Sea-Doo dealer.
WATER FOUND IN BILGE
1. Bailer system malfunction.
– Have system inspected by an authorized Sea-Doo dealer.
2. Exhaust system leak.
– Refer to an authorized Sea-Doo deale
r.
3. Carbon ring at drive shaft worn.
– Refer to an authorized Sea-Doo dealer.
______________
159
To Next Page
Loading...
Need help?
General