Sea-doo 2012 Sea Doo RXT series - Monitoring System; Fault Codes

TROUBLESHOOTING GUIDELINES
ENGINE LACKS ACCELERATION OR POWER
1. Jet pump water intake clogged.
– Clean. Refer to JET PUMP WATER INTAKE AND IMPELLER CLEANING in
SPECIAL PROCEDURES section.
2. Damaged impeller or worn-out wear ring.
– Replace. Refer to an authorized Sea-Doo dealer.
3. Engine oil level too high.
– Refer to an authorized Sea-Doo dealer.
4. Weak spark.
– Refer to ENGINE MISFIRES, RUNS IRREGULARLY.
5. Engine management system fault detected (check engine pilot lamp is
ON).
– Refer to MONITORING SYSTEM.
6. Clogged injectors.
– Refer to an authorized Sea-Doo dealer.
7. Low fuel pressure.
– Refer to an authorized Sea-Doo dealer.
8. Water in fuel.
– Siphon and replace.
9. Engine damaged by water ingestion.
– Refer to an authorized Sea-Doo dealer.
WATERCRAFT CAN NOT REACH TOP SPEED
1. Jet pump water intake clogged.
– Clean. Refer to JET PUMP WATER INTAKE AND IMPELLER CLEANING in
SPECIAL PROCEDURES section.
2. Damaged impeller or worn-out wear ring.
– Replace. Refer to an authorized Sea-Doo dealer.
3. Engine management system fault detected (check engine pilot lamp is
ON).
– Refer to MONITORING SYSTEM.
4. Faulty supercharger and/or intercooler (supercharged models).
– Refer to an authorized Sea-Doo dealer.
WATERCRAFT STAYS IN NEUTRAL AFTER OPERATING THE IBR LEVER
1. The iBR gate stays in neutral.
– Release the throttle to idle RPM.
– Press the CRUISE button to activate the slow speed mode.
– Return to shore using the slow speed mode. Refer to an authorized Sea-Doo
dealer.
158
______________