MULTIFUNCTION GAUGE
– DISPLAY
– FAULT CODES
– KEY MODE
– SETTINGS.
Then pressthe SETbuttontoenter that
function.
NOTE: The fault code function is only
available when there is an active fault.
The settings function is only available
when the engine is shut off.
Function Description
Lap Timer
Thelaptimercanbeusedtorecordup
to 50 individual lap times.
To activate and use the lap timer, carry
out the following:
1. Press the MODE button repeatedly
until LAP TIME is visible in the multi-
function display.
smo2010-002-111
FUNCTION SELECTED - LAP TIME
2. Press the SET button to enter the
function, the lap timer will be acti-
vated and visible in the display.
lap
smo2010-002-112
LAP TIMER ACTIVATED
3. To start the timer, press the SET but-
ton.
NOTE: The timer starts immediately
when pressing the SET button.
4. To record each lap time, press the
SETbuttonatthestartofeachlap.
NOTE: The lap time will be recorded,
the lap counter in the numerical display
will count the number of laps recorded,
and the timer will continue to run.
lap
2
1
smo2010-002-113_a
1. Lap time, first lap
2. Lap count 1
5. To save the last lap and stop the
timer, press the MODE button.
_______________
65
To Next Page
Loading...
Need help?
General